Having a healthy tan helps you look and
feel better, modern spray tan machines are very safe and only use nontoxic
mainly plant based sprays and solutions. They work by reacting to the amino
acids in your dead skin, turning them a slight bronze colour or a giving the
appearance of having a light tan.
This quick guide will help you successfully
use your spray tan machine.
Follow these simple steps to produce a
great long lasting spray tan:
Exfoliation
Exfoliation is the process of removing all
loose or dead skin, it can be done by using by gently scrubbing the body or
with the use of an exfoliating agent. Cleopatra was famous for bathing in milk
because the mild acid in the milk gently cleaned and removed any dead skin and
giving her a beautifully clear complexion.
This cleaning of the skin first is very
important so that your tan will stay on your skin longer.
A
Cream Barrier
The application of a moisturizing cream
helps the tanning solution to be absorbed evenly and deeper into your skin.
Areas that are normally dryer such as hands, feet, knees and elbows especially
need have moisturizing cream applied to stop them absorbing larger amounts of
tanning solution and looking darker.
Your
Tanning Area
Ideally, a spray tan booth should be used,
but if not available then a bathroom or spare room can be used. Try not to
spray in areas where furniture of fabrics could be affected. You need good
ventilation to avoid breathing in the spray
The
Tanning Process
It’s always best to do more, lighter coats,
than trying to and make one heavy coat as you have much more control and can
avoid streaks and runs.
The basic process is almost the same for
all spray tan machines:
Start by adding about three ounces of spray
tan solution into the cartridge on the spray gun. Make sure you tighten the lid
properly so nothing can spill out.
Adjust the air flow control knobs so you
get a light even spray, the higher you set the control the darker the resulting
spray tan will be. If spraying children or those with very fair skin use a low
setting.
During the spraying process, you may need
to adjust this setting depending on the area you’re spraying
It is quite possible to spray yourself or
have a friend do it for you
Always hold the spray gun vertically to
ensure an even tone
For the face area, hold your breath and
spry in a smooth circular motion in short bursts in three different directions,
going from your forehead to the sides and then your temple to your chin
Spray the body in vertical stripes and
apply to the arms, armpits, legs, hands and feet lightly
Normally the tan will dry in about ten
minutes, depending on the solution and the spray tan machine you’re using.
As soon as you’re finished flush out the
spray gun with a flushing solution or fresh, clean water and wipe the hoses and
compressor with a damp cloth after ensuring the power is turned off.
Your spray tan machine is very easy to use,
first ensure you exfoliate and then apply a moisturizer. Use light, quick
strokes rather than trying to apply a heavy or thick coast and clean up
properly after finishing.
Comments
Post a Comment